Kitchen Shelf

In the kitchen there are places where there is not enough space for a full shelf, but something similar would not hurt. For example, there is not much space between the gas column and the stove, and even the pipes from above pass. Just for such inconvenient places I suggest to make a small shelf for useful trifles - salt, spices, etc.
 Kitchen shelf
You will need: - 16 mm thick plywood; - thin boards or plywood 10 mm thick; - pencil, ruler, compass; - drill, drill; - jigsaw; - chisel 10 mm wide, hammer; - scraper from hacksaw cloth or shoe knife; - PVA glue; - plywood 3 mm thick; - carnations, screws; - varnish, brush, sanding skin. Shelf consists of two racks, two shelves of different widths, behind the wall. Racks have decorative cutouts. Racks are mirror-symmetrical, so the dimensions are only for the right rack. polka-kuhonnaya.jpg "alt =" Kitchen shelf "title =" Kitchen shelf ">
 Kitchen Shelf We mark according to the drawing, we cut a decorative cutout in the corners with a feather drillthen we saw out with an electric jigsaw using a nail file for curvilinear cuts. To install the shelves need to make grooves. To the edges of the grooves were neat, even - with a shoe knife or scraper, using a metal ruler as a guide, we scratch the top layer of plywood along the border of the future groove. The scraper (tooth) is made from a piece of metal blade for a hacksaw (fig.5). The rest of the sample is done with a chisel. The grooves are 1 cm deep.
Kitchen shelf
 Kitchen shelf
 Kitchen Shelf
Rectangular shelves made of thin plates 1 cm thick or made of plywood also 1 cm thick.
Kitchen shelf
Kitchen shelf If there is no plank of sufficient width, you can glue the two at least - put glue on the ends, squeeze, put on a flat surface and press down with a load. After drying, cut with a jigsaw to the required size. For the back wall we take three-layer plywood. Pre-drilled holes for mounting on the wall.Holes can be either above the top shelf or below it.
 Kitchen shelf
When all the parts are made, they need to be sanded. The outer parts of the pillars and decorative opening a little bit to round out. If necessary, chips and defects should be puttied with a putty of the corresponding color and cleaned. For better adhesion (adhesion), prime the grooves and ends of the shelves with a weak solution of PVA. We assemble the construction on glue on a flat surface.
 Kitchen shelf
 Kitchen shelf
 Kitchen shelf
 Kitchen shelf

To prevent the shelf from sticking to the base, it is better to carry out the assembly on a piece of polyethylene (at least a cut package). After the glue dries, if necessary, we clean the joints and varnish the entire shelf. We prepare the prepared back wall with small nails or fasten with small screws.
 Kitchen shelf
Once again we coat the entire structure with varnish. All. Can be mounted on the wall.


Related news


Selenium, potassium, magnesium - vitamins for a healthy body
How to choose a level
What is bedding like
Megan Markle is going to break the palace protocol again
Thrush in women - symptoms, causes, treatment and diet
How to make a doll Kupavku
XIX St. Petersburg International Economic Forum. Results