How to make a wall of foam blocks

������Popularity recently won partitions, built of foam blocks. The material itself is attractive, due to its characteristics, and the walls of it are strong and fairly smooth.

Material characteristics

Foam blocks have such remarkable qualities as heat retention and good sound insulation. If we compare it with bricks, the density of the foam block is slightly lower, but the weight of the structure and the load on the foundation are reduced, and for private construction this is of particular value. The resulting surface is easily exposed to finishing, and the cost of foam blocks is low.
The disadvantages of the material are porosity and great lightness, due to which the attachment of the cabinet or shelf to the wall should not even begin. Finishing materials, such as primer and putty, will need more - they will be absorbed into the pores.

Masonry walls of foam blocks

For the construction of the partition you will need the material itself in sufficient quantities, glue to connect the blocks, construction tools, mounting foam.The marking must first be done - for this you need to determine the place where the future wall should be located, and then apply smooth lines on the floor, ceiling and existing walls. This can be done using the dyeing thread. This stage is necessary so that on the basis of the marking lines it is possible to build a flat partition that will not be bent in several places.
If there is no particular experience in performing this kind of work, the use of guides is necessary. This may be, for example, a wooden frame, which should be installed along the marking lines. In addition, you can stretch the line, a rope with which you can level the middle of the wall.
Next is the preparation of the base, as well as those places where the partition will be adjacent. They are trimmed, leveled if necessary, and treated with a primer. After that, you can proceed to the construction. Dissolve the adhesive according to the instructions printed on the packaging. The consistency should be medium in thickness.
Begin to lay out the wall, focusing on the guides. Vertical and horizontal walls can be checked using the building level. Each of the blocks should be well pressed to the next block and to the previous row.So in the future it will be possible to avoid significant shrinkage. Begin to lay out the first row with the whole foam block, and the next - with half. So it turns out laying �scrambled�, that is, in a checkerboard pattern. The partition thus acquires the necessary strength.
When you reach the ceiling, the work must be slightly suspended to allow the wall to dry out. This will take a couple of days. After drying, you can finish. The gap between the ceiling and the wall must be sealed with some material with good elasticity, which can smooth out the deformation and vibrations. Well suited foam. It is only necessary to treat it more carefully, so as not to overdo it with the quantity.

Related news

What is better than Visa or MasterCard?
How to make a building
Should I marry alpha males
A 13-year-old teen built his own mini house in the backyard
What is useful prunes
Money Flower
Effective use of the balcony