Anyone who has ever wondered "why the battery fails"", knows that most of the batteries fail because of the sulphation of the plates. This phenomenon is affected by all lead-acid batteries.I was surprised by the simplicity of the work of restoring the battery with an electronic desulfator. In fact, all the manipulations were to connect the device to the battery and the restoration of sulfated plates would begin. Moreover, the battery did not even need to be removed from the car, unscrew the plugs of the cans to drain off the excess gas and perform some other actions. Even a charger connection is required. Yes, and special control is almost unnecessary - threw up the terminals and go do your thing, and the device will do it all. Thanks to the device you will be talking about, you can not only restore your battery, but also prevent the batteries that are still in the ranks.Thus, you extend their service for years.
Desulphator Operation PrincipleDesulphator is powered by a battery, which it restores. For the same power circuit, it generates reverse short high-power pulses of high frequency. It has long been known that such pulses introduce lead sulfate molecules into resonance, and the result is a reverse process - desulfation and the battery restores its capacity and resistance. Of course, this recovery method has some drawbacks: not all batteries can be restored, but about 85 percent. And this, I will tell you, is a very good chance to try this method. Another disadvantage is a very long process of recovery, which can last from days to a month.
Build a desulfator
Testing desulfator operationIt is advisable to connect the desulfator to the battery through a fuse, amps so two.Although the strength of the pulses there is much more, but their duration is not enough to disable the fuse. After connecting the device, you should hear a faint squeak indicating the normal operation of the device.
Battery recovery processIt is advisable to fully charge the battery before restoring. If you are going to restore the battery standing on the ground, be sure to discard one power plug of the car, so as not to damage the electronics of your car. Next, connect the desulfator and wait. Waiting time is always individual.All you need to do is periodically monitor the battery — measuring the voltage to prevent a full discharge. It is necessary to measure the voltage when the desulfator is off, this is necessary. Maximum results can only be obtained after 4 weeks of continuous operation of the desulfator. Although the device is autonomous, I do not recommend leaving it unattended.
And our great-grandmothers in the field gave birth, or is it worth giving birth at home
Small apartment in the attic: 20 square meters, where everything is
Natalie Portman will play NASA astronaut
Orchid sprig workshop
What is micronidling
Emergency lamp for 15 hours of operation
Secrets of amazing ganutele technique